New bottom end obtained for the ute!
![Post Post](./styles/prosilver/imageset/icon_post_target.gif)
On Saturday a few friends and I went shopping for ute bits
We came home with a JDMYo 10:1 FE3 bottom end
It came out of a manual 4wd 1996 Capella wagon. Here's a picture:
![Image](http://stuff.fredcooke.com/new.10to1.fe3.engine/IMG_8968.JPG)
The head gasket got chewed up on the way home, but no damage was done. Turns super smooth, bores are unscoured. $69 NZ FTW![Smile :-)](./images/smilies/icon_e_smile.gif)
I even managed to lift it out of the back of my old man's ute, carry it 10m/30ft and put it down smoothly by myself! Can I pick it back up? No. But still...
I'll post pictures of the "build" in this thread once I get started on it. Until then, I have other EFI stuff to do on my daily driver.
Fred.
![Very Happy :-D](./images/smilies/icon_e_biggrin.gif)
![Smile :-)](./images/smilies/icon_e_smile.gif)
The head gasket got chewed up on the way home, but no damage was done. Turns super smooth, bores are unscoured. $69 NZ FTW
![Smile :-)](./images/smilies/icon_e_smile.gif)
I even managed to lift it out of the back of my old man's ute, carry it 10m/30ft and put it down smoothly by myself! Can I pick it back up? No. But still...
I'll post pictures of the "build" in this thread once I get started on it. Until then, I have other EFI stuff to do on my daily driver.
Fred.